ARCHIVED FORUM -- March 2012 to February 2022READ ONLY FORUM
This is the second Archived Forum which was active between 1st March 2012 and 23rd February 2022
If you have updated software of the Beolab Transmitter 1 did you have to reconfigure the speakers again or did the Transmitter 1 remember what it had before as far as what speakers were attached?
Thanks,
I went ahead and tried to update the wireless software on my six Receiver 1s. I followed the B&O Instructions. I did see the PL status light come on green then did flash to red for a couple of seconds, followed by a couple of seconds of flashing green. This matches what the instructions says will happen. Next the PL status light is to flash red and the Transmitter 1 will turn off. Mine PL status light turned solid green and stayed that way. The Wireless Indicator on the back remained a solid orange. After a couple of minutes with the PL status a solid green and the Wireless indicator a solid orange I unplugged the unit from the mains, waited over a minute then removed the updating USB stick followed by reinstalling the mains. The Transmitter 1 PL status indicator remained off. I fired up the attached Beosystem 4 and all appeared to be normal with sound emanating from all the channels. I guess all is good. Time will tell.