Beocenter 9500 no power to sliding doors Tape/CD

Reply

hooth67 Posted: Thu, Aug 17 2017 8:09 PM

rated by 0 users

I am new into beoworld

I bought an Beocenter 9500 type 2501 and have fully functions on touch glass ....but no movement on both sliding doors.

I have checked sliding mechanism and drive belts that is in good condition.

any tips?

Reply

Guy replied on Fri, Aug 18 2017 8:07 AM

rated by 0 users

The door motors have been known to fail - can you check that these are getting power with a multimeter?

(Welcome to Beoworld, by the way!)

Reply

hooth67 replied on Wed, Aug 23 2017 11:42 PM

rated by 0 users

Thank you and like this serious quality site about "beauty&eyecandy" from Denmark

I will check the motor circuit and feed circuit that the service manual describes.

Ottar.

Reply

Dushan replied on Fri, Oct 27 2017 10:57 PM

rated by 0 users

If you hear the motor buzzing, then the belts are worn/cracked. I found rubber bands that fit and replaced the belts. Am still looking for proper O-ring type belts. 1.5mm diameter with 34mm inside diameter. 

Reply

Dushan replied on Fri, Oct 27 2017 10:57 PM

rated by 0 users

If you hear the motor buzzing, then the belts are worn/cracked. I found rubber bands that fit and replaced the belts. Am still looking for proper O-ring type belts. 1.5mm diameter with 34mm inside diameter. 

Reply

joeyboygolf replied on Sat, Oct 28 2017 1:08 PM

rated by 0 users

Forum member Dillen will be able to supply the correct belts.