ARCHIVED FORUM -- March 2012 to February 2022READ ONLY FORUM
This is the second Archived Forum which was active between 1st March 2012 and 23rd February 2022
Hi,
I’m trying to convince my Beosystem 4 that it has a Beovision 4 (or 12) attached so that it will send commands to switch the panel on and off through the serial port. I am currently managing this via an IR wand, but the screen can occasionally go out of sync, hence my preference to use the serial port.
ive been on to B&O support, and they’ve been very helpful in identifying that the Beosystem 4 is not signalling via the serial port because the EDID info being sent back via the HDMI cable is not signaling a Beovision.
I’ve found a EDID emulator:
https://www.lindy.co.uk/audio-video-c2/hdmi-2-0-edid-emulator-p11244
but I need a Beovision 12 (preferably) or a Beovision 4 to connect the emulator to to be able to learn the EDID info.
is there anyone who has a Beovision who could help me if I send the emulator for learning? Note that as most Beovision 4s are connected via DVI, the BV12 would be easier.