ARCHIVED FORUM -- March 2012 to February 2022READ ONLY FORUM
This is the second Archived Forum which was active between 1st March 2012 and 23rd February 2022
i plan to change the beosystem 3 on a beovision 9 to a beosystem 4.
powerlink adapter, the monitor and the ir/auto contrast wiring doesn’t seem to be the problem. (found the cabling in the service manual)
but the beovision 9/beosystem 3 has a old motorstand with 5 pins:
1 - GND (Yellow)
2 - Turn L (Red)
3 - Turn R (Brown)
4 - Pos (Black)
5 - +12 (Orange)
and the beosystem 4 has 4 pins with can-bus:
MicroFit 4-pin
Pin 1 - CANL_C Negative CAN bus signal
Pin 2 - GND_STAND Ground for stand
Pin 3 - CANH_C Positive CAN bus signal
Pin 4 - 12V_STAND_C 12V supply for standTMDS.
is there any chance to control the old stand of the bv9 with the 4 pin can-bus of the beosystem 4? a adapter? or maybe change the motor and control of the bv9 stand with motor/control of a newer stand (bv11)?
thanks beoandy
BS Ouverture, BS 9000, AV 9000, Avant 32 DVD, BV9, BV6-22, BS 5, BS 4500, BS 7000, BC 9500, Beo6, BL Penta, F1000, BLGW, etc....
Dom
2x BeoSystem 3, BeoSystem 5000, BeoSystem 6500, 2x BeoMaster 7000, 2 pair of BeoLab Penta mk2, AV 7000, Beolab 4000, BeoSound 4000, Playmaker, BeoLab 2500, S-45, S-45.2, RL-140, CX-50, C-75, 3x CX-100, 3x MCL2 link rooms, 3x Beolab 2000, M3, P2, Earset, A8 earphones, A3, 2x 4001 relay, H3, H3 ANC, H6, 2014 Audi S5 with B&O sound, and ambio