LC1 programming with BL1000 MK3+

Hi,

I bought a pre-owned LC1 light controller, and I am trying to reprogram it using a beolink 1000 with light button. The manual on beoworld only shows tje mk1 and mk2 programming.

The LC1 works, and I can switch yo different lighting scenes.

However, I would like to know three things (for now ;):

1. How can I reset the current LC1 lighting scenes?

2. I am only able to control the lights using link-light-play/stop (also with the beo4: list (link)-light-go/stop). Is the LC1 set to be connected in a link room only? Can I also reset that?

3. The arrows up and down to dim the light do not work as explained in the manual. Should I use the volume buttons? Or the next track/previous track buttons?

4. Because I do not get any confirmation if I enter a programming sequence I am not sure if I am doing the right thing: I need to touch and hold the glass surface while entering the programming sequence, but should the light be switched off before I start (so when I touch and hold the surface the lights will be switched on), or is this not important?

Thanks in advance! In return for your help I will rewrite the LC1 manual for BL1000 MK3+ and Beo4, and upload it (is that possible?).

Guys?

Figured it out: it was set to work with MK1 beolink1000, and I confused the programming:

LINK-SHIFT-LINK-GOTO-0-STORE can be achieved with LINK-LIGHT-GOTO-0-STORE on a MK3 beolink1000.

Operation was perfect after this.