ARCHIVED FORUM -- March 2012 to February 2022READ ONLY FORUM
This is the second Archived Forum which was active between 1st March 2012 and 23rd February 2022
@ beojeff
just some thoughts on your hypothetical system.
you cannot assigns two times the same ML command to different sources
there are a limited amount of ML sources to be programming in the BLC
to control 2 ML masters you must have a NL BV in between in my opinion; are 2 BLC a NL setup?
to connect the BS4500 to a BLC why not use a Beolink converter T1611.
double
Carolpa: @ beojeff just some thoughts on your hypothetical system. you cannot assigns two times the same ML command to different sources there are a limited amount of ML sources to be programming in the BLC to control 2 ML masters you must have a NL BV in between in my opinion; are 2 BLC a NL setup? to connect the BS4500 to a BLC why not use a Beolink converter T1611.
Indeed, a Beolink Converter Type 1611 is what I was referencing -- used to connect ML and MCL. It's a bit confusing with the "new" converter also being called a Beolink Converter. What you said makes sense -- that you just do a source map on one BLC. Perhaps then, the 2nd BLC would just send that same source command as mapped on the NL side from the 1st BLC over to ML on the other side of the 2nd BLC.
Can this works?
BV11-55 ------ NL/ML Conv -----BS9000 ------ BV6-26----- BV7-32
Can I use Beomusic app?
BeoVision Haermony 65"...BeoLab 28 Anthracite....BeoLab 17 as REAR....BV10-32....BC6-26....Beosound 9000....Beosound 1 New York edt....Beogram 4002....Beoplay Emerge....Beoplay M5....Beoplay M3....Beoremote Halo....BeoRemote One BT....Beo6....Beo4....Beo4 Cinema....BeoLink 7000....Serene....H95 Black LTD....H9i Rimowa....6 x H6....Form 1....U70...
mr_anders_son:Can this works? BV11-55 ------ NL/ML Conv -----BS9000 ------ BV6-26----- BV7-32 Can I use Beomusic app?
stijndc:No you need Essence, Moment or Beoplay A9 to use the Beomusic app
- Flere
smile and enjoy the moment
Says so on B&O site
The BeoMusic app requires one of the new audio products (BeoSound Moment, BeoSound Essence or BeoPlay A9) to be present in order to be activated.
The BeoMusic page shows the supported products, for the app to function: http://www.bang-olufsen.com/beomusic
If other NL products (e.g. BeoVision 11, BeoVision Avant) are in the system, they can be controlled as part of the multiroom offering, but to a more limited extend (e.g. you can distribute sound to them, but you cannot fully control their sources). However, the requirement is that one of the previously mentioned audio products is available, for the activation of the app.
This is done due to a combination of technical and commercial/licensing reasons. I hope this clarifies.
Petros
The BV11 and the Converter must be on the same network.
In your case connected to your router.
The BV11 may be connected wirelessly, the Converter can inly be wired.
MM
There is a tv - and there is a BV