ARCHIVED FORUM -- March 2012 to February 2022READ ONLY FORUM
This is the second Archived Forum which was active between 1st March 2012 and 23rd February 2022
Got to the Beocord yesterday, everybody knows how to take of the top cover, so here goes. Take of the command panel, pres the taps. red arrows, to the inside and upwards with a screw driver, then carefully pull the panel up and out.Be careful there is a cable connection below.
Now take off all the red pressure taps, press down with a finger and wiggle a little with a screw driver between tap and chassis, careful, old plastic.
Free the PCB support and raise it to upright pos. both sides, green arrow, free the cables from the clamps, red arrows, pull the plug, blue arrow.
Loosen 2 screws just behind the front panel and tilt it forward to free the PCB.
Now lift up the PCB, careful, its very thin and may brake. Disconnect the command panel plug. When pulling the plugs place your fingers at the arrows and wiggle it little by little side to side until it comes lose. take out the 2 front panel screws. Pull the 2 plugs for the front panel and take it out.
Panel out, at the arrows you will see some taps that hooks into the chassis, remember these when you put it in again
Raise the panel and secure it with the supports on the back side.
Pull the plugs for the tape unit.
Unscrew the sound cable brackets, and the ground wire behind the power supply PCB
The other side one more ground.
Loosen the cable clamp, blue no arrow , just bend it with a plier and pull it out from the lower hole, cables free. Pull the 2 plugs, loosen the 2 PCB supports and lift out the PCB.
Unscrew 3 screws and lift out the tape unit.
The drawer motor and drive is secured with 1 screw, take it out and twist with a screw driver, lift out. Mine had no band, and I didn't find rests inside, so someone was here before me.
All out, take out the 4 screws.
Red arrow, this is not a tap, its a highs adjusting shim.
When the roller guides are out, be sure to place the shims so you know to get them back in the same place.
When you take apart the drawer guides, be careful with the E clips, I call them Jesus Christ, because thats what I scream when they fly through the work shop, they seam to have a life of their own.
Clean of all old grease (Iso alcohol) and add new grease, I use silicone grease.
Drawer drive, clean, grease, remember the blade spring pos.
At the tape unit you will find old grease at the red arrows, clean add new grease, I use a pipe cleaner and cotton swabs.
Now change all bands and caps, put it all together again adjust everithing and were done,
Will be be back with more.
Collecting Vintage B&O is not a hobby, its a lifestyle.
Søren Mexico:be careful with the E clips, I call them Jesus Christ
Nice pictures!
--mika
Nice work as usual.
This Beocord 5000 is a hidden gem, it is one of my favourite decks. It has the ability to play pre-recordeds very well. It is also an excellent recorder.
I love mine, and so will you Søren.
Jacques
A very good disassembly guide, Søren. Please copy-paste it into a wiki-entry
The Beocord 5000 is a fine deck, most of the electronics origin from the Beocord 8004. The tape head is nice and large, I quite like it for playing back all kinds of tape.
Vinyl records, cassettes, open reel, valve amplifiers and film photography.
Søren Hammer: ...most of the electronics origin from the Beocord 8004.
...most of the electronics origin from the Beocord 8004.
What ?
Martin