beocord 9000

Reply

lotus73jps Posted: Fri, Dec 20 2019 12:12 PM

rated by 0 users

hi the ppm recording level indicator on both left and right channels are not showing on record and playback  .so cannot record a tape need help as to what to look for ?thanks

Reply

Dillen replied on Fri, Dec 20 2019 12:18 PM

rated by 0 users

Correct cable used?
Input selector set correctly?

Martin

Reply

lotus73jps replied on Fri, Dec 20 2019 12:40 PM

rated by 0 users

hi martin cable is 7 pin from steve and input selector is   amp and level is line

Reply

Dillen replied on Fri, Dec 20 2019 12:53 PM

rated by 0 users

RECORD OPEN lit?

Martin

Reply

lotus73jps replied on Sat, Dec 21 2019 7:45 AM

rated by 0 users

hi martin yes the record is lit and the no store is flashing 

Reply

Dillen replied on Sat, Dec 21 2019 7:53 AM

rated by 0 users

If you are sure, that you actually have an output from whatever you record from, check the signal path inside the Beocord with a scope.
It could easily be a capacitor causing a missing voltage somewhere.

Martin

Reply

lotus73jps replied on Sat, Dec 21 2019 10:50 AM

rated by 0 users

hi martin ive hooked the 9000 to 3 of my units beomaster 8000 and 2 beocenters 9500 still the same results .as I have no clue were to start looking for signal path or capacitor it will have to go back on the shelf  . until I can find somebody like you who nows what there doing .once again martin thanks for your help