Beolab 11 wall mount what size bolts

Reply

badgersurf replied on Tue, Sep 19 2017 8:14 AM

rated by 0 users

Hi All,

Does anyone have any idea what size bolts the beolab11 fixes onto the wall mount?

Thanks

Toby

Reply

bigl666 replied on Tue, Sep 19 2017 5:09 PM

rated by 0 users

here it is from the manual:

Use the correct size and type of screws and wall anchors – taking into account the construction and condition of the wall. Use 3 flat-bottom head screws (Ø 4.2 mm – 0.16”) and wall anchors each with a minimum load rating of 50 kg (110 lbs).

Special notice about light partition walls If you intend to hang the BeoLab on a gypsum wall (also known as drywall or wallboard), the wall bracket must be fastened to a vertical stud. Mounting was evaluated for use on a drywall surface. Use 1 screw (Ø 4.2 mm – 0.16”), which penetrates the gypsum and are screwed a minimum of 50 mm (2”) into a vertical stud. Furthermore, use 2 additional screws of a type intended for gypsum walls.

good luck -)

cu

Stefan

Reply

badgersurf replied on Wed, Sep 20 2017 8:53 AM

rated by 0 users

Thanks Stefan for your response. I have the bracket attached to the wall, it is the size of the screws that bolt the Beolab onto the base of the wall bracket I am after. there are 4 screws and all it says in the manual I can find is that they are called F! but there is no size.

Hope someone can help.

Thanks

Toby

Reply

Hiort replied on Wed, Sep 20 2017 1:52 PM

rated by 0 users

badgersurf:

Thanks Stefan for your response. I have the bracket attached to the wall, it is the size of the screws that bolt the Beolab onto the base of the wall bracket I am after. there are 4 screws and all it says in the manual I can find is that they are called F! but there is no size.

Hope someone can help.

Thanks

Toby

Those bolts are supplied with the bracket, if I remember correctly. Right?

I guess you have to take both bracket and BL11 down to the "bolt shop" and try ot what may fit.