ARCHIVED FORUM -- March 2012 to February 2022READ ONLY FORUM
This is the second Archived Forum which was active between 1st March 2012 and 23rd February 2022
One of my Beolab 8000s stopped working. It has the red LED, but won't go green. I took it apart and found the foam had turned to mush. It was bad over what I assume is a thermocouple to measure the heat of the heatsync.Cleaning it all off and assembling on the bench, it all worked (yay).
But after I re-assembled it, I'm getting the red LED of death. It may not be what I thought was the problem.
Is there a guide of what to check for? I am handy with a soldering iron, multimeter and have a cheap USB scope if needed.
I think..there is many posts to these topic...