Sign in   |  Join   |  Help
Untitled Page

ARCHIVED FORUM -- March 2012 to February 2022
READ ONLY FORUM

This is the second Archived Forum which was active between 1st March 2012 and 23rd February 2022

 

How to make Beovision6 recognize the motorized stand?

rated by 0 users
This post has 3 Replies | 1 Follower

Seven
Not Ranked
Posts 9
OFFLINE
Bronze Member
Reply
Seven Posted: Thu, May 10 2012 12:38 AM

Folks,

I reconnected my BV6 (type 9251) to the motorized stand. Problem is, the stand does not move, not manually with the remote, not when turning it on/off. There is no menu called "stand" to be found anywhere.

Is there a procedure one needs to do after connecting a motorized stand so that the TV recognizes it, calibrates it etc? If so, how do I start this procedure?

Thanks!

JC
Top 150 Contributor
West Yorkshire
Posts 764
OFFLINE
Silver Member
Reply
JC replied on Thu, May 10 2012 9:20 AM

Try resetting the TV to factory default and unplug the TV from the mains. Unplug the stand from the TV and start again after a couple of hours.

 

Jonnie

Seven
Not Ranked
Posts 9
OFFLINE
Bronze Member
Reply
Seven replied on Thu, May 10 2012 7:44 PM

Will try, thanks!

CasperI
Top 500 Contributor
Posts 93
OFFLINE
Bronze Member
Reply
CasperI replied on Thu, May 10 2012 9:31 PM

You don't need to reset your TV to factory defaults, but you have to unplug the mains, connect the stand and then plug it back in. This should do the trick

Page 1 of 1 (4 items) | RSS
Need a cable? Just ask Steve at Sounds Heavenly
Sellong your B&O
Need a cable? Just ask Steve at Sounds Heavenly