ARCHIVED FORUM -- March 2012 to February 2022READ ONLY FORUM
This is the second Archived Forum which was active between 1st March 2012 and 23rd February 2022
Hello,
the "Line in" on one of my Beolab 6000 has stopped working, the power link is working fine though.
Has anyone else come across this problem, could it be a bad circuit board?
Best regards,
Riven
My B&O products: Beosound 9000, Beosound 2300, Beosound Century, Beolab 8000, Beolab 6000, Beolab 4000 x2, Beolab 3500, Beolab 2000, Beolab 10, Beolink Active x2, Beotime, Beo5 x2, Beo4, A9 keyring x2, LC2 dimmer x6 and growing....
Likely a bad solder at the phono socket, perhaps a faulty mode switch, but it could also be a component failure in the autostart circuitry. Impossible to say without inspecting, but I'm sure it can be repaired.
--mika
Ok, thought it was something like that. Will have to bring it in to my dealer to let him check it out.