ARCHIVED FORUM -- March 2012 to February 2022READ ONLY FORUM
This is the second Archived Forum which was active between 1st March 2012 and 23rd February 2022
Hi,
I'm just trying to program my Beo5 from scratch.
I allready managed to program my favorite internet-radio stations via the Beolink-PC2 which is used in a single room.
In an other room (not linked to the first one) I want to conrol my window shade screens. They are controled with my Beo4 or Beolink 1000 when I enter this button combination:
LIGHT + 3 + ^ to close screens
LIGHT + 4 + ^ to open screens
I tried with both BOType Beo4 and Beo5 without success:
0:000:LIGHT:LIGHT
Delay: 50ms
0:000:LIGHT:CIFFER_3
0:000:LIGHT:CURSOR_UP
Could you give me some help to get the right configuration?
Thanks'
Gerard
It's not CURSOR_UP, it's probably something called STEP_UP.
Cursor is for the joystick.
Beoworld app with direct photo upload and emoticons.
Thanks' that's it STEP_UP works
But on the Beo4 I only have to keep the ^ pressed and the screen is going down continusly.
With thw Beo5 STEP_UP I have to press the command 1000 times to get the screen down or up cm by cm .
Is there a command to have it running continusly?
There should be a STEP_UP_CONTINUOUS, or a C_STEP_UP.
The Beo4 sends STEP_UP when you press, then a series of "Continuous STEP_UP" until you release the key.
Thank's for the Continous Tip.But it's not the C_STEP_UP , in the ConfigTool under the button properties BeoIR I enter the following command :0:000:LIGHT:LIGHTDelay: 50ms0:000:LIGHT:CIFFER_3Delay: 50ms0:000:LIGHT:STEP_UPand I put a mark in the "continus"-Box under the Command-FieldThank's for helping.Is there a List out there with all the commands sent by the different buttons of the different B&O remote-controls, I have BeoLink 1000, Beolink 5000, Beolink 7000, Beo4 and Beo5.For information to all other forum members the Beolink 1000 command: LIGHT + 3 + ^ is needed to address my curtains on relay 3 (down) controlled by a CP70B B&O-Link Module from conson.com for more info see here