ARCHIVED FORUM -- March 2012 to February 2022READ ONLY FORUM
This is the second Archived Forum which was active between 1st March 2012 and 23rd February 2022
My BL3500 suddenly do not react to commands from the remote. Tried with several, so there is no problem with the remote. Tried to power off/on. No joy.
Looked in the Service Manual and is seams easy to replace the board with the IR receiver.
Is it easy?
No soldering?
Is it possible to still order from B&O?
/C
Livingroom: BL3, BL11, BV11-46 Kitchen: Beosound 1 GVA, Beocom 2 Bathroom: M3 Homeoffice: M3, Beocom 2 Library: Beosound Emerge, Beocom 6000 Bedroom: M5, Essence remote Travel: Beoplay E8 2.0, Beoplay EQ, Beoplay Earset
Common problem with these. I repaired several.
New boards are available, but don't know if the newer versions works with the older 3500's.
Thanks.
Is it just to pop in a new board or are there soldering required?
From what serial number should the new boards work?
No soldering required.
Sorry, I don't know about the serialnumbers between mk1 and mk2.
Beobuddy:No soldering required. Sorry, I don't know about the serialnumbers between mk1 and mk2.