ARCHIVED FORUM -- March 2012 to February 2022READ ONLY FORUM
This is the second Archived Forum which was active between 1st March 2012 and 23rd February 2022
Hi,
After reading several posts on here and searching other sources of information I still can´t get my head around this.
When wanting to run a beolab speaker in line mode via PL (BL12-3 (same as BL8002 i think)) does the signal ground really need to be jumped to the pin7 ("old" PL) or the shell of a RJ45?
looking at the picture below
https
is the jumper from 2 to 7 or the "blue" to the shell of the rj45 just to get any potential braiding/shield to be connected to ground for (well) shielding. or does it have an effect on the speaker?
I have the 8pin DIN to RJ45 from Bosscom which works fine from beomaster 3500 to BL12, and think i can just connect a converter, same type as used for aux in on the master directly to the Bosscom and to the 12´s. this will yield the same as the connection shown above except for the jumper.
in summary, is the jumper between 2 and 7 required by the speaker?
thanks in advance
BR
Goran