ARCHIVED FORUM -- March 2012 to February 2022READ ONLY FORUM
This is the second Archived Forum which was active between 1st March 2012 and 23rd February 2022
I'm trying to integrate my raspberry pi setup into the BS3 setup I have here.
The BS3 has an 3.5mm IR blaster output. But does the BS3 drive it with 3V or 5V pulses?
If 3V I can directly attach it to GPIO pins on the pi, if not I'll have to step down the voltage or go blaster/IR receiver->PI.
Have a look at RaMaBo's 18 Jul post in this thread: https://archivedforum2.beoworld.org/forums/p/11215/98253.aspx#98253
I would expect his advice to apply to the BS3 also.