Sign in   |  Join   |  Help
Untitled Page

ARCHIVED FORUM -- March 2012 to February 2022
READ ONLY FORUM

This is the second Archived Forum which was active between 1st March 2012 and 23rd February 2022

 

Adjusting the no signal current on a Beomaster 1100

rated by 0 users
This post has 2 Replies | 1 Follower

Struer
Top 500 Contributor
London
Posts 106
OFFLINE
Bronze Member
Reply
Struer Posted: Fri, Sep 24 2021 12:03 PM
Hi all, I’m trying to adjust the no signal current on a Beomaster 1100

I have downloaded the manual for BM1100 and BC1800. I would have thought to adjust the trimmers (R155/ R255)to give a output of 10mv across resistors (R159) and (R259)as this seems like the logical steps

However on Beocenter 1800/BM1100 manual it says to adjust (R155/ R255) to 10mv across (2tp104/ 2tp204)

Although (2tp104)seems to be jumper wire and (2tp204)is obscured with another rectangular component.

Any advice most welcome

Pindsen
Not Ranked
Denmark
Posts 49
OFFLINE
Bronze Member
Reply
Pindsen replied on Fri, Sep 24 2021 7:30 PM

Hi,

In the service manual I have it says to measure across emitter resistor 5R113.

/Pindsen

Struer
Top 500 Contributor
London
Posts 106
OFFLINE
Bronze Member
Reply
Struer replied on Fri, Sep 24 2021 9:25 PM
Thanks for this.

Still a bit confused though
Page 1 of 1 (3 items) | RSS
Need a cable? Just ask Steve at Sounds Heavenly
Sellong your B&O
Need a cable? Just ask Steve at Sounds Heavenly