Sign in   |  Join   |  Help
Untitled Page

ARCHIVED FORUM -- March 2012 to February 2022
READ ONLY FORUM

This is the second Archived Forum which was active between 1st March 2012 and 23rd February 2022

 

Bv1 wake up

rated by 0 users
This post has 3 Replies | 2 Followers

mjmedlo
Top 100 Contributor
Posts 922
OFFLINE
Bronze Member
Reply
mjmedlo Posted: Sat, Mar 15 2014 12:58 PM
Mates

I have added a bv1/ml/nl converter to my large Ml network.

I use an mlgw for control via iDevice.

I can't get the bv1 to 'wake' from an mlgw command.

It responds when it is turned on, but will not initiate turning itself on with only a gateway command.

Any thoughts?
BeoMegaMan
Top 150 Contributor
Posts 601
OFFLINE
Bronze Member
Reply
BeoMegaMan replied on Sat, Mar 15 2014 1:18 PM
Turn on the wake on LAN setting. I think there is also a mlgw setting in the device menu. Power saving needs to be off as well.

Ah, you know... A little B&O here, a little there 

Hermann_
Not Ranked
Posts 52
OFFLINE
Bronze Member
Reply
Hermann_ replied on Sun, Mar 16 2014 10:23 AM
Same problem with BV11. I have already disabled all power save modes and enabled wol.
BeoMegaMan
Top 150 Contributor
Posts 601
OFFLINE
Bronze Member
Reply
BeoMegaMan replied on Sun, Mar 16 2014 2:05 PM

Hermann_:
Same problem with BV11. I have already disabled all power save modes and enabled wol.

Make certain you have enabled your quick start timers and also set the IP address of the tv. You'll be good to go then. 

Ah, you know... A little B&O here, a little there 

Page 1 of 1 (4 items) | RSS
Need a cable? Just ask Steve at Sounds Heavenly
Sellong your B&O
Need a cable? Just ask Steve at Sounds Heavenly