ARCHIVED FORUM -- March 2012 to February 2022READ ONLY FORUM
This is the second Archived Forum which was active between 1st March 2012 and 23rd February 2022
I just connected my Penta 2 to a carver 65 watt amp with a NAD pre-amp.and the one speaker started to hum, when the speaker output cable is switched the hum goes to the other speaker. So I changed cables and it remained the same???
when I shut the components down both speakers remain on green light stays lit and both hum, when I turn the mode switch on the speaker to off hum stops and light changes to amber.
Is there a compatibility issue between the carver amp and speaker amp?
could speaker amp need repair, is there a way to check and a place that can repair them if necessary.