Beosystem 3 MK1 Supported video output.

Reply

bophile Posted: Thu, Sep 10 2015 3:17 PM

rated by 0 users

Hello Friends,

I'm in the process to upgraded to Full HD  the panel (an Old  HD ready 1366x720p 42" Panasonic Plasma) hooked to  a Bosystem3 MARK 1 (DVI Display out) .

Reading Beosystem3 threads here and in the archived forums and also asking around some dealers , I'm still confused if the Beosystem3 is able to output Full HD (1980x1024p) signal. It's running 4.17a SW version (I know it's old) , but I have understood that starting from version SW version 3 the full HD was supported.

Any clues ?

Also if somebody has the BS3 system manual (SW version 3 or superior, you can read the software version on the front page of the manual) could you share what are you reading at the video output section around page 6.5 ?

Thanks a lot.

Reply

frog replied on Thu, Sep 10 2015 4:11 PM

rated by 0 users

I'm nowhere near the screen right now but if you go into the engineering section of the menu (iirc menu, red, go) go to the monitor section then choose non-B&O display and set the parameters to 1080i.

not sure that this is exactly correct, but should be close - was some years ago I did it!

regards

frog

Reply

bophile replied on Thu, Sep 10 2015 4:36 PM

rated by 0 users

Thanks ! will try that out.