Sign in   |  Join   |  Help
Untitled Page

ARCHIVED FORUM -- March 2012 to February 2022
READ ONLY FORUM

This is the second Archived Forum which was active between 1st March 2012 and 23rd February 2022

 

Beosound 9000 mk1

rated by 0 users
This post has 5 Replies | 3 Followers

Alain Verbeke
Not Ranked
Belgium
Posts 18
OFFLINE
Gold Member
Reply
Alain Verbeke Posted: Mon, Jun 25 2018 10:07 AM

Does anybody know if an original B&O Part 8420001 CD mechanisme would fit a Besound 9000 MK1. Apparently this part was used in the MK2 version. But I would like to use it in a MK1. Would that work?

 

Roger
Top 200 Contributor
Norway
Posts 417
OFFLINE
Bronze Member
Reply
Roger replied on Tue, Jun 26 2018 12:09 PM

It may - you need 8005294 (8420203 from s/n 12402833) for type 2521-2530.

8420001 will fit mk2, ie type no 2561-2567 if above s/n 15143261 and below s/n 15143261. The 8420001, aka Module 96, came with a new plug connection - so it may be possible to swap plugs and make mechanical alterations to make the drive fit, but will not fit out-of-the-box.

Roger

Alain Verbeke
Not Ranked
Belgium
Posts 18
OFFLINE
Gold Member
Reply
Alain Verbeke replied on Tue, Jun 26 2018 1:46 PM

Thanks Roger. That's helpfull. 

Alain

 

Alain Verbeke
Not Ranked
Belgium
Posts 18
OFFLINE
Gold Member
Reply
Alain Verbeke replied on Thu, Jul 19 2018 2:22 PM

Hi Roger,

I’m still struggling with my Beosound 9000 MK1.
The previous owner seem to have mis-matched the laser mechanism and the control PCB…
The PCB (CD-servo & decoder) that is my unit is printed B&O C6143388 and 2 with 42 (in a circle) . See pictures attached.
The wires on the plug 45, pin 5 & 6 are not connected anywhere…
I can’t find this PCB 42 on any of the service manual for the BS9000, not the MK1 nor MK2 nor MK3.
I just bought a brand new CD mechanism VAM 1205 that does not want to focus. Everything else works fine.
So, my question: can this VAM1205 work with this board? Or what board do I actually need and is it available somewhere?
thanks in advance and kind regards
Alain
PS: can not add pictures; don't know  why

 

Roger
Top 200 Contributor
Norway
Posts 417
OFFLINE
Bronze Member
Reply
Roger replied on Sat, Jul 21 2018 6:42 AM

Hi Alain - I´m on vacation and away from my manuals until Mid August. Hopefully someone can help out before I return! 

Anyone with manuals available to assist?

Thanks,

Roger

Beobuddy
Top 25 Contributor
Utrecht, The Netherlands
Posts 3,972
OFFLINE
Founder
Reply
Beobuddy replied on Sat, Jul 21 2018 8:59 AM

The servo/decoderboard next to the laserunit has to be marked with “VAM1205 only” at the connector where the wide flatcable is connected. 

That’s in the original situation. A PCB board marked with 42 is a replacementboard which was used with a new mechanism years ago. 

Page 1 of 1 (6 items) | RSS
Need a cable? Just ask Steve at Sounds Heavenly
Sellong your B&O
Need a cable? Just ask Steve at Sounds Heavenly