ARCHIVED FORUM -- March 2012 to February 2022READ ONLY FORUM
This is the second Archived Forum which was active between 1st March 2012 and 23rd February 2022
Beogram 8002. Recapped the main pcb and the sub boards. The 47uf cap replaced in the microprocessor box.I have been over this board under magnification and corrected all that I have seen.
Here's what it will (and will not) do:
Press turn- it spins
Speed select, is does this fine
Press play- the table spins up, tonearm comes out some but not near the record edge.
Press right and left - it will do this
Press stop- this only works after you press turn. If you try to stop from "play" it does nothing.
Tonearm will not lower.
I beleive I am close on this but at this point I am stumped.
Please, advice needed.
Update: I opened the LDC and found a spiderweb on the one section. Cleaned this out and now when you push play the arm goes all the way to the center of the record (doesn't drop). If I move the arm back slightly and press play the arm will drop and will play for about a minute before lifting and returning to home.
The other change from before is now 33.33 reads 99.99 and 45 reads 55.00