ARCHIVED FORUM -- March 2012 to February 2022READ ONLY FORUM
This is the second Archived Forum which was active between 1st March 2012 and 23rd February 2022
Hi, advice needed. I'm trying to rebuild a Beogram 4002. The small pulley wheel on the end of the brass lead screw has a split centre, so cannot be secured properly. Has anyone repaired the fixing or know of a modern replacement? Thanks
Hi, I've found that a slightly modified meccano pulley works very well, at least until I find an original. All the best Richard
Well done! The problem with these is that there a number of different sizes - the hole in the middle can be different sizes! I was sent one by a friend that didn't fit - I repaired my original instead.
Peter
It should be lego
blah-blah and photographs as needed